Double 'C' shell aluminum case joined by front and rear H=130, L=171, D=273 mm

Very light and robust electronics containers, made entirely of aluminum with a particularly rational and elegant design with clean lines, rounded corners and few closing screws, with countersunk heads and recessed into the aluminum sheet.

There is no fixing screw on the front and rear panels of the box.

The container is made up of two "C" shaped shells in 1.5mm thick aluminum which are particularly light but stable and precise, the shells are joined by two front and rear panels also in 3mm thick aluminum

Shells and panels are blind but cutouts, holes, slots and any type of processing can be made on request.

All surfaces are in natural brushed anodized aluminum to eliminate the annoying and unsightly fingerprint effect typical of shiny sheet metal.

The electronics can be assembled directly on the base of the container or on a special plate supplied separately.

Available accessories: lifting feet, rubber feet.

Front and rear covers can be customized on request with the possibility of holes and cut-outs for connectors, displays, ventilation, cable passage, vents, provisions for electronics, etc.

Discounts for resellers, integrators, instrumentation manufacturers

The codes in the table are read as follows: e.g.: 213ta128
213 = external depth in mm
ta = indicates the family of containers
1 = thick height in rack units 44 mm
28 = width expressed in TE (or HP Horizontal Pitch - horizontal pitch, where 1 HP equals 0.20 inches = 5.08 mm).


For sizes other than those indicated in the table it is still possible to request a quote by contacting the sales office using the email indicated in the contact details at the bottom of the page.